14
Dashcam to record videos when an impact is
detected while the vehicle’s engine is o. The
Dashcam will power on automatically and
record a 20-second video clip then shut down.
NOTE: Feature only available when the Dashcam
is hardwired to the fuse panel. Hardwiring kit
(AC533513) sold separately.
Loop Record
• Select the duration of each recorded footage
between 1 minute, 3 minutes and 5 minutes.
Oldest and unlocked les will be overwritten
once the storage limit is reached.
Time Lapse
• Select between normal and time lapse video.
• Time lapse videos are recorded at a lower
frame rate to create an accelerated time eect
during playback. (Refer to page 19)
NOTE: Please set Slow Motion to OFF to activate
the Time Lapse function.
Exposure
• Adjust the exposure level between +2.0,
+1.0, 0, -1.0 and -2.0 for dierent lighting
conditions.
G-Sensor
• Adjust the G-Sensor sensitivity between O,
High, Mid and Low.
• When the G-Sensor detects a sudden impact
such as a collision, it'll automatically "lock"
the footage and move it into the Event
folder so that it doesn't get overwritten by
the loop record feature.
Motion Detection
• Motion Detection On/O. The Motion
Detection function allows the Dashcam
to start recording automatically when a
moving object is detected. Please only use
this function when the car is parked.
NOTE: Motion Detection does not support
Slow Motion or Time Lapse Mode.
Parking Monitor
• Parking Monitor On/O.
• The Parking Monitor function allows the
To Next Page
Loading...
Need help?
General
