Tyre ?are T650 - Pressure Alarm Value Setting

Parameters setting
06
High pressure alarm value setting of
the first axle
In the standby interface,press and hold SET to enter into the setting mode.
Press + to select to setting interface "HI"on first axle as below. Press SET then
press + or - to select high pressure alarm value you want. And press SET to
confirm setting ,finally press and hold SET for 3 seconds to save the setting
Low pressure alarm value setting of
the first axle
In the standby interface,press and hold SET to enter into the setting mode.
Press + to select to setting interface "LO"on first axle as below.Press SET then
press + or - to select low pressure alarm value you want. And press SET to
confirm setting ,finally press and hold SET for 3 seconds to save the setting
and exit to standby.
High pressure alarm value setting interface of the first axle
Low pressure alarm value setting interface of the first axle