Leaving valet mode:
REMOTE VEHICLE immobilisation (ANTI-HIJACK Function)
IMPORTANT! Anti-hijack function can be used only in countries where the Reg.97 ECE
does not apply. In opposite case, the homologation of DS512 VSS becomes invalid.
If anti-hijack function was enabled in the DS512 configuration, there is a possibility to stop
the vehicle by sending SMS command:
When the SMS is received, the DS512 starts anti-hijack procedure: the LED lights up, the
acoustic (siren) and optical (hazard indicators) signalisation is enabled.
25 seconds after start of signalisation, the engine is being immobilised by breaking a circuit
with a immobilisation relay. The anti-hijack procedure has no time limit. Both engine
immobilisation and signalisation lasts until the SMS disabling the anti-hijack is received.
Both antihijackon and antihijackoff commands are confirmed by SMS with vehicle status sent
to the mobile phone. The anti-hijack is terminated by entering the service mode.
PROGRAMMING VSS PIN AND MOBILE NUMBERS FOR PAGING ALARM
The user can change VSS PIN, set number of mobile phones, which receive SMS with
information when the alarm is triggered in the vehicle and set the phone numbers for these
mobiles. Up to 3 mobile phone numbers can be programmed.
The command is:
where:
current VSS PIN current (old) VSS PIN or default VSS PIN (12345) in the device
new VSS PIN VSS PIN which will be set as the new one
number of mobile phones
number of mobile phones, which receive SMS with information
when the alarm is triggered in the vehicle 0-3
first phone number, second phone number, third phone number
mobile phone numbers which are informed about triggering the
alarm in the vehicle in international format with ‘+’ at the beginning,
for example: +44xxxxxxxxx
To Next Page
Loading...