Tytan DS 512 - Remote Check of Vehicle Status; The Confirmation of the Command Is the SMS with Information

Digital Systems
7
The confirmation of the command is the SMS with information:
Example:
sets new VSS PIN 54321, and sets 3 mobile phone numbers which will be notified if the
alarm is triggered. The unit responds with SMS confirmation:
REMOTE CHECK OF VEHICLE STATUS
The DS512 allows to check status of vehicle and security system with a command:
The DS512 sends back the SMS with information on vehicle and security system status. The
information about status is sent in a full or simplified form, depending on settings configured
in the device during installation. The full version of system status is:
The simplified version of system status is:
The optional information in vehicle status SMS are:
The information on door/trunk/bonnet being opened or on the ignition switch status allows to
validate the theft risk when the vehicle status is sent. The detailed information about status
configuration should be provided by the installer after installation.
VSS PIN set: {new VSS PIN} number of mobile phones: {number of mobile
phones} {first phone number} {second phone number} {third phone number}
12345 setgsm 54321 54321 3 +44501123456 +44502123456 +44503123456
VSS PIN set: 54321 number of mobile phones: 3 +44501123456 +44502123456
+44503123456
{VSS PIN} status
device status: {OK / ALARM was triggered!}
system: {disarmed / armed / armed w/o sensors / armed w/o
trunk and sensors / ALARM in progress! / disarmed
(rearming) / valet mode / ANTI-HIJACK in progress! /
ANTI-HIJACK vehicle stopped}
device status: {OK / ALARM was triggered!}
system: {ready / ALARM in progress! / valet mode /
ANTI-HIJACK in progress / ANTI-HIJACK vehicle stopped}
door/trunk/bonnet: {closed / opened}
ignition: {on / off}