Tytan DS 512 - ARMING; DISARMING of the VSS Via SMS; Reading Alarm Memory; Clearing Alarm Memory

Digital Systems
9
ARMING / DISARMING OF THE VSS via SMS
(only when DS512 is set to VSS mode)
If the DS512 is set to the VSS mode, SMS commands can arm or disarm VSS.
DS512 responds with a status SMS. Important! after disarming, the VSS waits for door
opening or switching on the ignition. If any door is not opened or ignition is not turned on, the
VSS rearms after 30 seconds, in order to prevent accidental disarming.
If the power door locks are controlled by the DS512, arming and disarming via SMS locks
and unlocks power door locks.
READING ALARM MEMORY / CLEARING ALARM MEMORY
(only when DS512 set to VSS mode)
In order to read from DS512 memory sources of last 3 alarm cycles, the following SMS
should be sent:
The DS512 responds with SMS:
Alarm memory can be cleared by sending SMS:
After receiving the SMS, DS512 clears alarm memory and sends the SMS with cleared
reasons of previous alarm cycles. If the command cannot be executed (the DS12 does not
work in VSS mode) the information is sent:
IMPORTANT!
After installation and verification of DS512 operation, please check the default VSS
PIN (12345) with personal code and configure the mobile phone numbers to be notified
about VSS or vehicle status.
{VSS PIN} arm
{VSS PIN} disarm
{VSS PIN} alarmlog
Sources of last alarm cycles:
{first source}
{second source}
{third source}
{VSS PIN} clearlog
The command cannot be executed.