VEHICLE GPS LOCALISATION
In order to localise the vehicle geographical position, the following SMS should be sent:
After the SMS is received by the DS512, the GPS receiver is being started. In regular
operation, the GPS receiver is disabled and the vehicle GPS position is not known. The GPS
receiver is started when the alarm is triggered or after this SMS command. The reply for the
command is:
After the GPS position is set the following SMS is sent:
Use the link to open the online map with the current position of the vehicle. If the phone
cannot display the online map or does not have internet access, the link can be used in any
internet browser or coordinates can be used in dedicated tracking software or online map
portals.
If the GPS position cannot be fixed, the SMS info will be sent:
If the system is not equipped with GPS receiver, the following information will be sent:
LOCKING / UNLOCKING OF THE VEHICLE via SMS
On some vehicles, there is possibility to control power door locks with DS512. In such case,
the power door locks can be locked or unlocked with SMS command. Locking and unlocking
does not enable or disable VSS. The commands are:
The DS512 responds with a status SMS.
If the command cannot be executed, the following information is being sent:
To Next Page
Loading...