EasyTravel – ET1B User’s Manual Rev. 0708 17
8. GENERAL MAINTENANCE AND INSPECTIONS
Minimum maintenance should prevent unnecessary repairs.
Keep Your EasyTravel Shining
Wipe the seat clean with a damp cloth. Protect the painted parts with a coat
of auto wax.
WARNING: Water or Excessive moisture around the controller unit or electri-
cal connections may cause contamination of electrical circuitry, damage and
malfunction as well as personal injury. Do not leave your EasyTravel in the
rain or in excessively humid locations.
Daily Checks
With the EasyTravel switched off, check that the hand control lever me-
chanism returns to the rest position when you push and release. If there is a
problem do not use the EasyTravel and contact your authorized dealer.
Weekly Checks
1. Throttle test: Pull the throttle to the full speed position and switch ON
the Power switch. The EasyTravel should not move and the LED on the
panel should flash. If the EasyTravel does move – do not use your
EasyTravel. Contact your authorized dealer.
2. Automatic brake and drive test: This test should be carried out on a
level surface with at least 3’ / 1 m. clear space around the EasyTravel:
Switch the EasyTravel on.
Move the control lever only slightly in the forward direction until you hear a
“click” when the brake disengages. The EasyTravel should start to move
forwards slowly.
Immediately release the throttle. You must be able to hear a “click” when
the brake engages back, within a few seconds.
Repeat the test in the reverse direction.
If you do not hear the brake operating, or the EasyTravel does not move
slowly in the expected direction – do not use your EasyTravel. Contact your
authorized dealer.
To Next Page
Loading...
Need help?
General
