17
CONTROL SETTINGS - COMBO/ICE MAKER
Models BI 2015 and
2075FF are turned
ON with the ON/OFF
switch recessed in
the front grille (see
Figure 21). In these
units, the control dial
is used only for tem-
perature control.
Figure 21
1. Plug the appliance cord into a 115V polarized and grounded elec-
trical outlet.
2. All units are shipped in the ON position.
3. Open the water supply valve in the main water source. As soon as
the ice maker mold reaches the proper temperature, the ice
maker mechanism will fill the mold with water. The first cubes may
be small because of air in the water line. Subsequent cubes will be
of standard size. Allow 2 hours for frost free models.
It is possible that dirt or scale will dislodge in the water line.
Always throw away all ice cubes made during the first two
to three hours of operation.
To Next Page
Loading...
Need help?
General
