U-Line MINI PAK'R H-1604 User Manual (English)

Questions and Answers:

S
Stephen DavisAug 5, 2025
What to do if my U-Line Industrial Equipment Mini Pak'r™ machine has no power?
- J
  juliefloresAug 5, 2025
  If your Mini Pak'r™ machine isn't getting power, check these things: * Make sure the power cord is plugged securely into both the machine and the outlet. * Check that the circuit breaker is turned ON at the electrical panel. * Ensure the power switch on the machine is in the ON position. * Replace the main fuse if it has blown. * Tighten the belt cover screw with a screwdriver if the belt cover(s) are open.
B
Brandon VincentAug 12, 2025
Why do air cushions from my U-Line Industrial Equipment not hold air?
- D
  davistammyAug 12, 2025
  If the air cushions aren't holding air, here are a few possible reasons: * The air fill tube might not be inside the film; reload the film onto the air fill tube. * The seals might be leaking; in that case, adjust the seal temperature. * There might be too much air fill; try reducing the amount of air being used.
V
Veronica AndersonAug 19, 2025
What to do if U-Line Industrial Equipment film jams frequently?
- D
  Denise PriceAug 20, 2025
  Frequent film jams can occur in your equipment if the blade is dull. In that case, replace the blade. It can also happen if the drive belts are worn; in that case, replace both drive belts.
L
Larry RoseAug 27, 2025
How to stop U-Line Industrial Equipment machine automatically?
- S
  Samuel RogersAug 27, 2025
  If the machine doesn't stop automatically, it might be because the length control is set to continuous. To fix this, press the (+) or (–) length control buttons to set the desired length of air cushion production.