PAGE 7 OF 7 0715 IH-1604
ERROR CODES
Consult the chart below if the Display shows an Error Code and the red LED flashes. Try the appropriate action for the
problem, then press the STOP/RESET Button to resume operation.
DISPLAY CODE ISSUE ACTION
E1 Cover open Make sure covers are closed
E2 Jam/end of roll In case of jam, open belt cover and remove jammed film carefully.
E3 Temp. Too high Contact Uline for assistance. (800-295-5510)
E4 Temp. Too low Contact Uline for assistance. (800-295-5510)
E5 Temp. Not rising Contact Uline for assistance. (800-295-5510)
E6 No roll detected Press stop/reset. This may clear the error. If not, display will show "sty" (standby). Advance the
film slowly at the front of the machine so the film roll rotates. The display should show the seal
temperature and then "rdy" (ready). If the error can't be cleared, contact Uline for assistance.
(800-295-5510)
TROUBLESHOOTING
OPERATING ISSUE CAUSES RECOMMENDATIONS
No power to Mini Pak'r™
Machine
Power cord is unplugged
Circuit breaker OFF
Power Swtich OFF
Main fuse is blown
Belt cover(s) open
Plug power cord into Mini Pak'r™ Machine and outlet
Turn circuit breaker ON at Electrical Panel
Turn Power Switch ON
Replace Mains Fuse
Tighten Belt Cover Screw with Screwdriver
Film won't advance Film Roll installed backwards
Using incompatible film
Turn film roll around (page 2)
Install compatible roll
Air Cushions do not hold air Air Fill Tube not inside film
Air Pump not working
Seals leaking
Too much air fill
Reload film onto Air Fill Tube (page 2)
Contact Uline for assistance
Adjust seal temperature (page 5)
Reduce air fill (page 5)
Film jams frequently Blade is dull
Drive belts are worn
Replace Blade (page 6)
Replace both Drive Belts (page 6)
Machine won't stop
automatically
Length control set to continuous Press + or – Length Control Buttons to set desired length
of Air Cushion production (page 4)
ERRORS AND TROUBLESHOOTING
π
CHICAGO • ATLANTA • DALLAS • LOS ANGELES • MINNEAPOLIS • NYC/PHILA • SEATTLE • MEXICO • CANADA
1-800-295-5510
uline.com
To Previous Page
Loading...
Need help?
General
