U-Line MINI PAK'R H-1604 User Manual

PAGE 3 OF 7 0715 IH-1604
BASIC USE
1. When machine is switched on, display shows "sty"
(Standby). (See Figure 7)
2. Mini Pak'r™ detects the film roll once it is
loaded.
3. Green LED on Start Button begins flashing. Machine
warms up.
4. Display shows the seal temperature during warm-up.
5. Once seal temperature is reached, green LED stops
flashing.
6. Display shows "rdy" (Ready). (See Figure 8)
7. Press Start Button to begin making Air Cushions. (See
Figure 9)
8. Air Pump blows air into the Film, after a few seconds
the Drive Motor advances the Air Cushions through
the Seal Bar and Slitting Blade.
9. Finished Air Cushions emerge at front of
machine.
10. Press Stop Button to stop production.
NOTE: Machine is preset to operate
continuously, producing Air Cushions until the
roll is empty. To create a fixed length of Air
Cushions, use the Length Control buttons (see
Length Control, page 4).
START
MINI PAK˙R
™
FP International
air cushion machine
(877) 594-5160
www.fpintl.com
STOP/RESET
Length Control
(in feet)
Green LED
• Blinks on warm-up.
• Steady when ready.
Start Button
• Switch on to warm up
machine.
• Starts production of Air
Cushions.
LED display
Set Air Fill Level
Set Seal Temperature
Stop Button
• Stops Air Cushion production.
• Resets machine after an error is
adjusted.
Red LED
Figure 8
Figure 7
START
MINI PAK˙R
™
FP International
air cushion machine
(877) 594-5160
www.fpintl.com
STOP/RESET
Figure 9
START
STOP
CONTROL PANEL
BASIC OPERATION

U-Line MINI PAK'R H-1604 Specifications

General

Brand	U-Line
Model	MINI PAK'R H-1604
Category	Kitchen Appliances
Language	English