U-Line S-107 User Manual

PAGE 1 OF 3 0821 IS-107
π S -107, S -1717
POLY STRAPPING KIT
1-800-295-5510
uline.com
INSTRUCTIONS
THREADING METAL BUCKLES
1. Insert end of strapping up through center of the
buckle and around open leg to form a loop.
Pull top tight around leg. (See Figure 1)
2. Wrap strapping around package. Loop strapping
around remaining open leg of buckle. Pull loop
tight around leg. (See Figure 2)
3. Pull both top ends of strapping in the opposite
direction to manually tighten. (See Figure 3)
USING TENSIONER AND CUTTER
1. Place strapping between tensioner rods. Raising the
handle, flip tool 360 degrees. (See Figure 4)
2. Pull tool to desired level of tension. (See Figure 5)
3. Use blade on side of tool to cut away excess
strapping. (See Figure 6)
Figure 3
Figure 4
Figure 2
Figure 1
Figure 5
Figure 6
Para Español, vea página 2.
Pour le français, consulter la page 3.

U-Line S-107 Specifications

General

Brand	U-Line
Model	S-107
Category	Indoor Furnishing
Language	English

Summary

Threading Metal Buckles

Insert Strapping Through Buckle

Insert strapping through buckle center and around open leg to form a loop.

Loop Strapping Around Buckle Leg

Wrap strapping around package and loop around the remaining open leg of the buckle.

Manually Tighten Strapping Loop

Pull both top ends of strapping in opposite directions to manually tighten.

Using Tensioner and Cutter

Position Strapping in Tensioner

Place strapping between tensioner rods and flip tool 360 degrees.

Apply Tension with Tool

Pull the tool to achieve the desired level of tension.

Cut Excess Strapping

Use the tool's blade to cut away excess strapping.