Trouble Shooting
Before returning the machine for repairing, please check the followings.
If the machine still can not operate properly, stop using the machine
immediately and contact us for repair authorization.
The inspection and maintenance of this machine are easy, and we have
many reference videos. Feel free to contact us if you have any problems.
Specifications
Power Requirement
Input Voltage Range
Wattage
Dimensions
Net Weight
Body Material
Tape Length
Tape Width
Feeding Speed
Max. Outside Dia. of Roll
Accessories
100-240VAC 50/60Hz
±5%
25W
116mm(W) x 140mm(H) x 213mm(D)
1.6
KG.
ABS
5mm ~ 999mm
6mm~ 60mm
220mm/sec. (using Craft Tape)
300 mm
Power Cord
2A
Fuse [Built-In Inlet]
Separator / Guide Plate / Tweezers
Tape curls excessively.
The length of the tape is
different from the set
length.
The BLADE can not move
smoothly.
After removing piece of
tape, the next piece does
not feed under AUTO
mode.
The POWER SWITCH is
on but the machine can
not run.
The machine is not grounded.
The ROLLER LOCK is disengaged.
The adhesive of tape is too strong.
The elasticity of tape is too strong.
The BLADE UNIT is not in a proper
position.
The mode is set MANUAL.
Some debris are covering on the
SENSORS.
The tape can not goes through the
SENSORS.
The tape has extremely low
reflectance.
The AC CORD is loosen.
The FUSE has been blown.
Check ground on cord.
Engage the ROLLER LOCK to apply tension.
Correct the setting after cutting several test pieces.
Check the BLADE UNIT and push down on the
housing firmly.
Set the mode to AUTO.
Remove the debris.
Use SEPARATOR to narrow the tape lesser than
25mm,
Do not bring strong illuminant close around the
SENSORS.
Some types of tape may not be used under AUTO
mode.
Check the AC CORD then plug in the outlet firmly.
Replace the FUSE.
Stop using the machine immediately even though
the FUSE is blown again after replace.
Warranty
We warrant to the original purchaser of the product that will be free
form defects in material or workmanship for as long as the original
purchaser owns the product, when given normal wear and proper
usage.
The limited warranty for the machine shall be for a period of one year
f
rom the date of purchase.
The spare parts such as Cutting Blades, Rollers, are not covered
under the warranty period as they are considered as "wear parts".
This warranty is only valid if the product:
◆Was not damaged while being installed.
◆Was operated in accordance with products's specifications,
instructions and any technical support directions.
◆Was not modified or damaged by tempering, user error, accident,
disaster, abuse, misuse, power supply, power application,
alternation, repair, modification, a fix or replacement by someone
other than the original product.
14
Remarks ◆The specifications are subject to change without prior notice.
◆The length of the tape may differ from the set length depending upon
the type of the tape or its condition.
◆Some types of tape available with the machine may not be cut
depending upon conditions.
Tape keeps getting stuck The output roller or its side gear is
worn or damaged
Inspect the parts #504 #506 #511 #512 #513
#526 #522 and #531 for wear and damage. If
yes, replace it.
To Next Page
Loading...