uAvionix AV-30-C - Alerts and Alert Limits

UAV-1003947-001, AV-30-C, Installation Manual 39
Rev E
NONE
No source available
AVLINK
AV-Link – Do Not Enable unless authorized by
follow-on approval
13.1.7 AID Mode
Set AID MODE to NONE.
There are up to 3 options for the AID MODE, which controls the method of
aiding the AHRS DG functionality.
Value
AHRS Aiding Source
NONE
None used
MAG1
Internal magnetometer provides correction data to
DG – Do Not Enable unless authorized by follow-
on approval
MAG2
Internal magnetometer provides correction data to
DG and aiding to core AHRS algorithm – Do Not
Enable unless authorized by follow-on approval
Rotate the center knob until “AID MODE” is displayed. If the internal
magnetometer is available (P/N UAV-1003429-002) then you will have a
choice of NONE, MAG1, and MAG2. If the internal magnetometer is not
found, only “NONE” will be displayed.
Figure 16 - AID Mode Selection