uAvionix AV-30-C - OAT Interface; GPS Navigator Interface

UAV-1003947-001, AV-30-C, Installation Manual 43
Rev E
13.2.3 OAT Interface
If an Outside Air Temperature (OAT) probe is connected, utilize the display
customization guidance provided in the Pilot’s Guide to configure the display
to show OAT in at least one textual display field.
Figure 22 - OAT Indicator
Note that OAT calibration is performed in the Setup procedures. This step
only ensures that the OAT probe is detected properly.
13.2.4 GPS Navigator Interface
If a GPS Navigator is connected, utilize the display customization guidance
provided in the Pilot’s Guide to configure the display to show GPS
navigational data in at least one textual display field.
The image below shows a typical configuration that the pilot may setup.
Figure 23 - GPS Data Elements