uAvionix echoUAT - Traffic on COM 1 via GDL90

53
UAV-1001006-001
ECCN 7A994
Appendix C-10 Traffic on COM 1 via GDL90 Configuration Note
When echoUAT pin 6 (COM2 RX) is connected to a GPS source with a low baud rate,
traffic delivery to an EFIS on pin 5 (COM2 TX) will also be impacted. To improve the
responsiveness of traffic it can be optionally output on COM1 (Pin3) of the echoUAT.
Note that in this configuration the EFIS cannot be set for control of the echoUAT
Settings for Traffic on COM1 are as follows:
Equipment
Setup
Source
Control
Source
Traffic /
Uplink
COM1
Rate
COM1
Data
COM1
PHY
COM1
PROTOCOL
GDL90 EFIS,
GRT, AFS,
ETC
APP
Transponder
Monitor
EFIS
COM1
38400-
115200
81N
RS232
GDL90
After echoUAT is configured for COM1 Traffic the EFIS will need configured to receive the data.
As an example the GRT EFIS would be set to the following settings:
Serial Port Input: ADS-B
Serial Port Rate: 115200