Need help?Do you have a question about the uAvionix echoUAT and is the answer not in the manual?
General| Type | ADS-B Transceiver |
|---|---|
| Category | ADS-B |
| Frequency Range | 978 MHz |
| Mounting | Surface mount |
| Operating Temperature | -20°C to +55°C |
| Standards | DO-260B |
| Power Output | 250W nominal |
| Interface | RS-232 |
| GPS Input | NMEA 0183 |
| Compliance | TSO-C154c |
Details the primary functions and capabilities of the echoUAT system.
Covers compliance with industry standards and regulations for operation.
Describes the standard hardware interfaces provided by the echoUAT.
Details the software and electronic hardware configuration for the system.
Lists the components included in the product package.
Identifies and explains markings present on the equipment.
Prohibits modifications and use beyond the device's designed purpose.
States that there are no deviations from the Minimum Operational Performance Standards.
Warns about potential pilot distraction from altering configurable options.
Clarifies that aircraft adaptations require separate approval.
Provides instructions for unpacking and visually inspecting the unit.
Offers guidance on selecting a suitable mounting location and procedure.
Highlights critical warnings related to the installation process.
Details the pinout for the Molex connector used for power and data.
Details power connection and status LED indicator meanings.
Specifies the cooling requirements for the device.
Provides technical benefits and recommendations for aircraft-grade power wiring.
Provides considerations for antenna placement and installation.
Discusses cable characteristics, loss, and routing for optimal performance.
Instructions for establishing a Wi-Fi connection to the echoUAT.
Details the parameters that can be configured for the echoUAT system.
Details setting the GPS antenna offset for accurate positioning.
Guides on configuring the system's installation parameters.
Guides on updating and verifying the system configuration.
Instructions for using the echoUAT with an EFB application.
Wiring diagrams for various transponders and GPS units.
Illustrates connections between EFIS units, GPS, and the echoUAT.
Details setup and serial port configurations for GRT EFIS.
Provides further setup details for GRT EFIS including flight ID and aircraft data.
Illustrates the wiring for a Safe-Fly to EchoUAT pre-wired cable.
Details system setup and control configuration for Dynon Skyview.
Explains how to determine and set the baud rate for Apollo SL70.
Configuration for AFS EFIS on COM2 for traffic and weather.
Configuration for AFS EFIS on COM1 for traffic and weather.
Details the serial connection for Garmin GNS units.
Steps to configure the GNS for ADS-B+ output.
Details the serial connection for Garmin GTN units.
Steps to configure the GTN for ADS-B+ output.
To Next Page