118
CHAPTER 4. MOTOR VEHICLE PREPARATION
UPON RECEIPT FROM THE MANUFACTURER
Dealers must sell the motor vehicle only after pre-purchase
preparations, specied in the service book.
If the motor vehicle was delivered to the sales point and traveled
more than 100 kilometers (OST 37.001.082-82), all the prelimi-
nary preparations for ferrying must be carried out as a part of the
pre-purchase preparations.
CHAPTER 5. MOTOR VEHICLE RUNNING-IN
Long-term and fail-safe service life of the motor vehicle
depends on a greater extent on the run-in of the parts during the
initial service period.
The running-in kilometrage equals to 2,500 km.
During the running-in period, observe the following rules:
1. Crankshaft rpm of engine must not exceed the 3/4 of the
nominal rotational speed.
2. Do not exceed the motor vehicle nominal load.
3. Do not drive along the tough roads (deep mud, sand, steep
inclines, etc.).
4. Do not haul the trailer.
5. Do not change the oils lled in the engine and units at the
manufacturing plant.
6. Check and adjust the tension of the auxiliary unit drive
belts if necessary, as they reach the maximum stretch during the
running-in period.
7. Check the temperature of brake drums and discs and in case
of raising the temperature, adjust the parking brake actuator or
brake pedal free play.
8. Check the temperature of wheel hubs and in case of raising
the temperature, loosen the tightness of bearing.
9. Check condition of all attachments and connections of
pipes; eliminate leakages of oils, fuel, coolant and hydraulic
uid, if you nd it.
To Next Page
Loading...
Need help?
General
