3
The nameplate is located on the rear panel of the unit and contains electrical and other technical data
specific to this unit.
Be sure the unit is properly grounded. To minimize shock and fire hazards, proper grounding is important.
The power cord is equipped with a three-prong grounding plug for protection against shock hazards.
Your unit must be used in a properly grounded wall receptacle. If the wall receptacle you intend to use is
not adequately grounded or protected by a time delay fuse or circuit breaker, have a qualified electrician
install a proper receptacle.
Make sure the receptacle is accessible after the unit has been installed.Do not use extension cords or an
adapter plug with this unit.
Do not use extension cords or an adapter plug with this unit. However, if it is necessary to use an
extension cord, use an approved Dehumidifier extension cord only (available at most local hardware
stores).
To avoid the possibility of personal injury, always disconnect the power supply to the unit, before
installing and/or servicing.
Electrical lnformation
To Next Page
Loading...
Need help?
General
