Need help?Do you have a question about the Ubiquiti airFiber 24 and is the answer not in the manual?
General| Frequency Band | 24 GHz |
|---|---|
| Antenna Gain | 33 dBi |
| Beamwidth | 3° |
| Wind Survivability | 200 km/h |
| Certifications | CE, FCC, IC |
| Channel Bandwidth | 100 MHz |
| Throughput | 1.4+ Gbps |
| Encryption | AES 128-bit |
| Polarization | Dual Linear |
| Interface | 10/100/1000 Ethernet |
| Power Method | PoE |
| Operating Temperature | -40 to 55° C |
Discusses key considerations for planning a point-to-point link, including environmental factors and topology.
Guides on properly connecting the PoE adapter and power source to the airFiber unit.
Explains accessing the interface and configuring wireless mode, duplex, and frequencies.
Instructions for adjusting the Master unit's azimuth and elevation for signal optimization.
Details configuring wireless parameters and network settings like IP addresses and netmasks.
Guides users on accessing the device's configuration interface via a web browser.
Details initial steps to establish a preliminary link between Master and Slave units.
Details fine-tuning the Master unit's alignment to improve signal strength.
Step-by-step guide for physically mounting the airFiber AF-24 unit using the pole mount bracket.
Details steps for connecting Ethernet cables, including TOUGHCable and PoE adapters.
Provides detailed steps for fine-tuning alignment to achieve a symmetric link between units.
Explains the importance and procedure for grounding the airFiber unit for safety and warranty.
Offers alignment tips and explains using the LED display for preliminary link establishment.
Guides on using the airFiber Configuration Interface for advanced alignment adjustments.
Guides configuration of basic wireless settings: mode, link name, country, duplex, output power.
Guides on configuring network settings for management access, including IP address and DHCP fallback.
Explains Ping Watchdog for monitoring and auto-rebooting the airFiber AF-24.
Details the process of updating the airFiber AF-24 firmware, including checking for updates.
Describes the Align Antenna tool for optimizing antenna direction to maximize link signal strength.
Provides essential safety instructions, warnings, and electrical safety requirements for the device.
To Next Page