Need help?Do you have a question about the Ubiquiti airFiber 5 and is the answer not in the manual?
General| Encryption | 128-bit AES |
|---|---|
| Max. Power Consumption | 40W |
| Power Method | Passive PoE |
| Certifications | FCC, IC, CE |
| Receiver Sensitivity | -90 dBm |
| Antenna Gain | 23 dBi |
| Range | Up to 100+ km |
| Operating Temperature | -40 to 55° C |
| Wireless Approvals | FCC Part 15.407 |
| Ethernet | 1 x 10/100/1000 Mbps |
| Channel Bandwidth | 10/20/40 MHz |
| Power Supply | 24V, 0.5A Gigabit PoE Adapter (Included) |
Details the necessary tools and environmental requirements for installing the airFiber.
Guides through the initial setup steps, including connecting power via PoE.
Explains how to access and configure the airFiber device through its web interface.
Provides step-by-step instructions for assembling and mounting the airFiber hardware.
Details the procedures for grounding the device and connecting Ethernet cables.
Guides on how to align antennas using the configuration interface and LED displays for optimal link.
Describes the process of adjusting and securing the Master and Slave units to establish a wireless link.
Configures essential wireless parameters like mode, link name, country, and duplex.
Covers frequency selection, channel bandwidth, and modulation rate adjustments.
Details how to set up AES encryption with HEX or ASCII keys for wireless security.
Assists in precisely aligning the antenna for maximum link signal strength.
Highlights warnings regarding water submersion and electrical storm usage.
Provides essential guidelines for safe electrical connection and operation.
Details Industry Canada compliance and RF exposure safety guidelines.
To Next Page
