Ubiquiti Loco5AC User Manual

Loco5AC Quick Start Guide
https://dl.ubnt.com/qsg/Loco5AC/Loco5AC_EN.html[1/6/2020 4:15:20 PM]
NanoStation loco Zip Tie
Package Contents
Installation Requirements
Shielded Category 5 (or above) cabling with drain wire should be used for all outdoor
wired Ethernet connections and should be grounded through the AC ground of the PoE.
We recommend that you protect your networks from harmful outdoor environments and
destructive ESD events with industrial-grade, shielded Ethernet cable from Ubiquiti. For
more details, visit
ui.com/toughcable
Surge protection should be used for all outdoor installations. We recommend that you use
two Ethernet Surge Protectors, model ETH-SP, one near the NanoStation loco and the
other at the entry point to the building. The ETH-SP will absorb power surges and safely
discharge them into the ground.
Loco5AC Quick Start Guide

Ubiquiti Loco5AC Specifications

General

Model	Loco5AC
Frequency Band	5 GHz
Throughput	450+ Mbps
Antenna Gain	13 dBi
Operating Temperature	-40 to 70° C (-40 to 158° F)
Dimensions	179 x 77.5 x 59.1 mm (7.05 x 3.05 x 2.33")
Weight	180 g (6.35 oz)
Wireless Standard	802.11ac
Operating Frequency	5150 - 5875 MHz
Power Method	Passive PoE (Pairs 4, 5+; 7, 8 Return)
Operating Humidity	5 to 95% Noncondensing
Max. VSWR	1.5:1
Wireless Approvals	FCC, IC, CE
RoHS Compliance	Yes
Networking Interface	10/100 Ethernet
Processor	MIPS 74Kc
Memory	64 MB
Power Supply	24V, 0.5A Gigabit PoE Adapter (Included)
Mounting	Pole-Mountable