Ubiquiti NanoBeam M5 Setup

1
Ubiquity NanoBeam M5 Setup for Truck Scales
1. Purchase the Ubiquity NanoBeam M5 bridge here on Amazon: Nanobeam M5 bridge
2. To access the Nanobeam web interface, your computer must be in the same subnet range as the unit.
3. Click Start, and type Control in the search field, then select Control Panel.
4. Click on Network and Internet.
5. Click on Network and Sharing Center.
6. On the left pane, click the Change adapter settings link.
7. Right-click on your computer’s Ethernet network adapter and select Properties.
8. Select the Internet Protocol Version 4 (TCP/IPv4) option.
9. Click the Properties button.
10. Select the Use the following IP address option.
11. Set the IP address to 192.168.1.1 .
12. Set the Subnet mask. (e.g., 255.255.0.0).
13. Click OK.
14. Click Close again to close the network adapter properties.
15. Connect the truck scale intercom to a POE switch, plug a computer into the POE. Connect the first bridge device
to the POE injector that came with it. Plug the LAN port of that POE injector into the POE Ethernet switch (can
use a non-powered port). Do NOT plug the wireless bridge directly into the same POE Switch as the intercom
since they use different voltages.

Ubiquiti NanoBeam M5 Specifications

General

Frequency	5 GHz
Throughput	150+ Mbps
Range	15+ km
Antenna Gain	16 dBi
Processor	Atheros MIPS 74Kc, 560 MHz
Memory	64 MB DDR2 RAM, 8 MB Flash
Operating Humidity	5 to 95% Noncondensing
Wireless Approvals	FCC, IC, CE
RoHS Compliance	Yes
Operating Frequency	5170 - 5875 MHz
Max. Power Consumption	8W
Gain	16 dBi
Power Method	Passive PoE (Pairs 4, 5+; 7, 8 Return)
Max. VSWR	1.5:1
Polarization	Dual Linear
Enclosure	Outdoor UV Stabilized Plastic
ESD Protection	± 24 kV Contact / Air
Operating System	airOS
Power Supply	24V, 0.5A PoE
Operating Temperature	-40 to 70° C
LEDs	Power, LAN
Dimensions	189 x 189 x 125 mm
Weight	530 g (1.17 lbs)
Mounting	Pole Mounting Kit included