Need help?Do you have a question about the Ubiquiti PowerStation2 and is the answer not in the manual?
General| Brand | Ubiquiti |
|---|---|
| Model | PowerStation2 |
| Category | Wireless Access Point |
| Language | English |
Opens the web browser and types the default IP address of the PowerStation2/LiteStation2/LiteStation5 device for login.
Configures IP settings required for device management purposes, either from DHCP or manually.
Specifies the SSID of the wireless device (Access Point) to which the subscriber station will associate.
Specifies the 802.11 wireless network mode for subscriber station communication with the wireless device.
Chooses the security method (WEP, WPA, WPA2, None) to protect data and control network access.
Changes the default administrator's password for security reasons using the System menu.
Applies configuration changes and reboots the device to implement settings.
Configures general wireless settings like SSID, country code, output power, and data rates.
Specifies the operating mode of the device (Station, Station WDS, Access Point, AP WDS).
Specifies the SSID for Access Point mode or ESSID for Station mode association.
Selects the IEEE 802.11 mode for your wireless network.
Selects the security mode for your wireless network (None, WEP, WPA, WPA2).
Enters the WEP key for wireless traffic encryption/decryption.
Enters a passphrase for WPA/WPA2 encryption.
Specifies the operating network mode: Bridge or Router.
Specifies IP mode: DHCP for dynamic, Static for fixed IP address.
Enters the IP address of the device.
Enters the subnet mask of the device.
Enters the Gateway IP address.
Enters the DNS IP address.
Configures WLAN interface IP address, Netmask, NAT, and DHCP Server.
Configures LAN (Ethernet) connection settings.
Modifies the administrator password to protect device configuration.
Reboots the device or resets all system parameters to factory default values.
To Next Page