Ubiquiti UniFi nanoHD User Manual (English)

To Next Page

UniFi nanoHD AP Mounting Bracket Ceiling Backing Plate

Screws (Qty. 4) Flat Head Screws (Qty. 4) Keps Nuts (Qty. 4)

Screw Anchors (Qty. 4) Gigabit PoE* (48V, 0.5A) with

Mount Bracket

Power Cord*

Package Contents

* Included only in the single-pack of the UAP-nanoHD.

Installation Requirements

CAT5 cable

Phillips screwdriver

Drill and drill bit (6 mm for wall-mounting or 3 mm for ceiling-mounting)

UAP-nanoHD Quick Start Guide

Other manuals for Ubiquiti UniFi nanoHD

Need help?

Do you have a question about the Ubiquiti UniFi nanoHD and is the answer not in the manual?

General

Wireless Standards	802.11 a/b/g/n/ac/ac-wave2
Max Aggregate Throughput	2033 Mbps
Frequency Bands	2.4 GHz, 5 GHz
MIMO	4x4
Networking Interface	1x 10/100/1000 Ethernet Port
Supported Voltage Range	44-57VDC
Max. Power Consumption	10.5W
BSSID	Up to 8 per Radio
Operating Temperature	-10 to 70° C (14 to 158° F)
Operating Humidity	5 to 95% Noncondensing
Ports	1x 10/100/1000 Ethernet Port
PoE	802.3af
Weight	300 g
Wireless Security	WPA-PSK, WPA-Enterprise (WPA/WPA2, TKIP/AES)
Power Method	802.3af PoE
Max. TX Power	2.4 GHz: 26 dBm, 5 GHz: 26 dBm
Data Rates	802.11a: 6, 9, 12, 18, 24, 36, 48, 54 Mbps; 802.11b: 1, 2, 5.5, 11 Mbps; 802.11g: 6, 9, 12, 18, 24, 36, 48, 54 Mbps
Maximum Speed	1733 Mbps (5 GHz), 300 Mbps (2.4 GHz)
Mounting	Wall/Ceiling
Management	UniFi Controller
Antenna Gain	3 dBi (2.4 GHz), 4 dBi (5 GHz)