Ubiquiti UniFi Security Gateway PRO - Front Panel Button

Front Panel Button
Reset
Button Description
Reset
Resets to factory defaults. The UniFi
Security Gateway Pro should be running
after bootup is complete. Press and hold
the Reset button for about 10 seconds
until the right LED on the WAN2 port starts
flashing and then becomes solidly lit.
After a few seconds, the LED will turn off,
and the UniFi Security Gateway Pro will
automatically reboot.
Back Panel
Mounting Holes
Power
Ventilation Holes
Mounting Holes
Fans
Note: There are additional ventilation holes on the sides
of the UniFi Security Gateway Pro.