Need help?Do you have a question about the Ubiquiti UniFi Switch Flex and is the answer not in the manual?
General| Model | USW-Flex |
|---|---|
| Operating Temperature | -40 to 55° C (-40 to 131° F) |
| Total Non-Blocking Throughput | 5 Gbps |
| Switching Capacity | 10 Gbps |
| Forwarding Rate | 7.44 Mpps |
| Supported Voltage Range | 44 to 57VDC |
| Certifications | CE, FCC, IC |
| PoE Input | 802.3af/at |
| PoE Output | 802.3af/at |
| Power Method | PoE |
| ESD/EMP Protection | Air: ± 24 kV, Contact: ± 24 kV |
| Operating Humidity | 5 to 95% Noncondensing |
| Mounting | Wall, Pole |
| Management Interface | UniFi Network Application |
RJ45 ports support 10/100/1000 Mbps Ethernet connections.
Port 1 supports 802.3af/at/bt PoE standards.
Describes the status of the system LED indicator.
Instructions for mounting the UniFi Switch on a wall.
Indicates PoE status for ports 2 through 5.
Shows link, speed, and activity status for ports 1 through 5.
Physical size and weight of the UniFi Switch Flex.
Details on RJ45 ports, speed, and management interface.
Information on power input and supported PoE modes.
Details on PoE output and max power consumption.
Supported voltage range, operating temp/humidity.
Information on LEDs and ESD/EMP protection.
Regulatory and compliance certifications.
Critical safety instructions and warnings for operation and environment.
Information on voltage, frequency, and qualified service.
Details on FCC rules and compliance for the device.
Compliance information for ISED Canada regulations.
Compliance marks for Australia and New Zealand.
Information regarding CE marking compliance.
To Next Page
