Ublox SARA-R4 Series System Integration Manual

SARA-R4/N4 series - System Integration Manual
UBX-16029218 - R11 Handling and soldering Page 121 of 157
 To prevent electrostatic discharge through the RF pin, do not touch any exposed antenna area. If there
is any risk that such exposed antenna area is touched in a non-ESD protected work area, implement
adequate ESD protection measures in the design.
 When soldering the module and patch antennas to the RF pin, make sure to use an ESD-safe soldering
iron.

Ublox SARA-R4 Series Specifications

General

Brand	Ublox
Model	SARA-R4 Series
Category	Control Unit
Language	English