EasyManua.ls Logo

UEC DSD 700 - User Manual

UEC DSD 700
32 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
DSD 700 OPERATING INSTRUCTIONS 1
Contents
Unpacking ............................................................................ 2
Safety ...................................................................................2
Preface ................................................................................. 2
Digital Satellite Services ..................................................... 2
Conditional Access ............................................................. 3
Smart Card ............................................................................. 3
Inserting the Smart Card ..................................................... 3
The Digital Satellite Decoder (DSD) ................................... 4
Display ................................................................................... 4
Front Panel Keys .................................................................... 4
Rear Panel Connections .......................................................... 4
Remote Control Unit ...........................................................5
Replacing Batteries in the RCU ................................................ 5
Getting Started .................................................................... 6
Installation of the satellite dish and cabling to the decoder ........ 6
Installation Indemnity .......................................................... 6
Setting-up the System ............................................................. 6
Switching on the Decoder at the Mains .................................... 6
Tuning your TV ....................................................................... 6
Adding a Modem ..................................................................... 7
Standby and Normal Modes ..................................................... 7
Optional Decoder Connections ................................................8
Introduction ........................................................................ 8
Hints to Quality TV System Configurations........................... 8
Satellite Decoder, TV (using SCART or RF
Interface) ...................................................................... 8
Decoder, TV (SCART or RF Interface), Hi-Fi ........................ 9
Decoder, VCR, TV ,Hi-Fi ..................................................... 10
Decoder, VCR, TV, Hi-Fi (using RCA Connectors) ............... 11
Two Satellite Decoders, TV, (using RF Connector) .............. 12
RCU UHF Button Selection Functions .............................. 12
Bouquet Selection ............................................................... 13
Selecting Specific Services ..................................................... 13
Selecting Services Directly ................................................. 13
Stepping through Services ...................................................... 13
Stepping using the RCU ...................................................... 13
Stepping using the Decoder Front Panel Keys .....................13
Selecting Specific Services from the EPG............................ 14
Selecting Services from the Information Bar ........................ 14
Controlling the Show .......................................................... 14
Volume Control using the RCU Keys .................................... 14
Volume Control using the Decoder Keys.............................. 14
Mute .................................................................................. 14
Displaying Subtitles or Teletext ............................................ 14
Subtitles ........................................................................ 14
Teletext ......................................................................... 14
Clock ................................................................................. 15
Selecting Soundtracks ........................................................ 15
Power Reset ...................................................................... 15
Signal Source Selection ...................................................... 15
Open TV Electronic Programme Guide ............................. 15
Using the EPG ......................................................................... 15
Open TV Information Bar .................................................... 16
Reminders ........................................................................... 16
Program Blocking ............................................................... 16
Menu Navigation Route ....................................................... 17
Using Menus ....................................................................... 18
Language Selection ................................................................ 18
Language Options in Guide & Menu .................................... 18
Soundtrack Options ............................................................ 18
Program Blocking Options ....................................................... 19
Blocking Options ................................................................ 19
Changing the Pin Code for Blocking ..................................... 19
Information Box Display Period ................................................ 20
Change PU:SE-PIN Code .......................................................... 20
Channel Arrangement Options ................................................. 20
Delete TV Channels ............................................................ 20
Sort TV Services ............................................................... 20
Original TV Channel Setup .................................................. 21
Delete Music/Radio Channels .............................................. 21
Sort Music/Radio Channels ................................................. 21
Original Music/Radio Channel Setup .................................... 21
Search Service Names ....................................................... 21
Mailbox ................................................................................... 21
Advanced Options .................................................................. 21
Change Dish Installation ...................................................... 21
LNB Configuration ......................................................... 21
Set LNB Power ......................................................... 22
LNB Setup ................................................................ 22
Signal Setup .................................................................. 22
Tune DSD ...................................................................... 22
Reset to Factory Defaults .............................................. 22
Loop Through Mode ....................................................... 22
Signal Detection ................................................................. 22
Information ......................................................................... 23
DSD Status ................................................................... 23
CA Status ..................................................................... 23
Loader Status ............................................................... 23
TV Installation .................................................................... 23
TV Type ........................................................................ 23
Aspect Ratio ................................................................. 23
UHF Tuning ................................................................... 23
Scart Source................................................................. 24
Scart Video Output ........................................................ 24
Change Modem Settings (if fitted) ....................................... 24
Local Time ......................................................................... 24
DSD Upgrade ..................................................................... 24
Troubleshooting ................................................................. 25
Specifications ...................................................................... 29
Hotlines ................................................................................ 30
Installation Settings ............................................................ 30
Notes .................................................................................... 31

Table of Contents

Questions and Answers

  • K
    Kent ThompsonAug 16, 2025
    What to do if the UEC Media Converter displays a blank screen?
    • H
      Haley DayAug 16, 2025
      If your UEC Media Converter shows a blank screen, ensure the power cord is securely plugged into a working mains outlet and that the mains switch is turned on. This should resolve the issue if the cause is simply a lack of power to the IRD.
  • R
    Randy JacksonAug 19, 2025
    Why is my UEC Media Converter video recording incomplete?
    • B
      Brianna TaylorSep 12, 2025
      An incomplete video recording on your UEC Media Converter typically occurs if you switch the IRD to standby mode or change to a different service during the recording process. To prevent this, avoid making any adjustments or selections using the RCU while a recording is in progress.
  • J
    Julie PhamAug 22, 2025
    What to do if my UEC Media Converter video recording is interrupted?
    • D
      David MclaughlinAug 22, 2025
      An interrupted video recording on your UEC Media Converter, where menus or text appear, or the sound level fluctuates, usually means you've pressed a button on the RCU during recording. To fix this, avoid pressing any buttons on the RCU while recording.
  • K
    kevin45Aug 25, 2025
    What to do if my UEC Media Converter remote control isn't working?
    • J
      Joseph GordonAug 26, 2025
      If your UEC Media Converter remote control (RCU) isn't working, start by checking if the batteries are correctly inserted. If they are, replace the batteries with new ones and test the RCU again.
  • D
    Diana DavidAug 28, 2025
    What does a small green dot on my UEC Media Converter mean?
    • B
      Brian ChapmanAug 28, 2025
      A small green dot on your UEC Media Converter indicates that the IRD is in standby mode. Press the standby button on the RCU to return to normal viewing.
  • D
    David KennedyAug 31, 2025
    What does it mean if my UEC Media Converter shows three flashing dashes and an error dot?
    • T
      Teresa SantosAug 31, 2025
      Three flashing dashes and an error dot on your UEC Media Converter can be caused by a faulty installation, signal problems, or heavy rain. You can check, repair, or replace cables, check the IRD installation settings, realign the dish, or replace it with an approved model. If problems persist, contact your Service Provider.
  • D
    Daniel Tucker DVMSep 3, 2025
    What to do if my UEC DSD 700 shows 3 flashing dashes and a red error dot?
    • J
      juliapattersonSep 3, 2025
      If you see 3 flashing dashes and a red error dot on your UEC Receiver, it may be due to a heavy thunderstorm. Please wait until the storm subsides. If the problem persists, check, repair, or replace cables, check the decoder installation settings, realign the dish or call the service provider.
  • C
    Charles CruzSep 6, 2025
    What to do if the error dot (red) appears on my UEC DSD 700 because of the Smart Card?
    • S
      Sean BrownSep 6, 2025
      If you see a red error dot on your UEC Receiver and suspect the Smart Card is the issue, try reinserting it. If the problem continues, it might be necessary to call your service provider.
  • C
    Christopher RamirezSep 9, 2025
    What to do if I entered the wrong PIN on my UEC Receiver and the display is blank?
    • J
      james40Sep 9, 2025
      If your UEC Receiver shows a blank display and you think it might be due to an incorrect PIN, refer to Programme Blocking in this manual. If you've forgotten your PIN code, consult your service provider.
  • A
    andersonsarahSep 12, 2025
    What to do if the Smart Card is not applicable to my UEC DSD 700 Receiver?
    • A
      Andrew ArroyoSep 12, 2025
      If the Smart Card is not applicable to this system, reinsert the Smart Card or call the service provider.

UEC DSD 700 Specifications

General IconGeneral
Power Supply12V DC
Smart Card ReaderYes
Frequency Range950 - 2150 MHz
Input Impedance75 Ohm
Weight1.2 kg
Supported Resolutions576i
Input Level Range-65 dBm to -25 dBm
DVB StandardDVB-S2