Need help?Do you have a question about the UEi EM201B and is the answer not in the manual?
Crucial safety advice, including tubing checks, gas leak response, and professional operation guidelines.
Procedure to zero the meter before use in a non-pressurized area for accurate readings.
Connect tubes to measure positive, negative, or differential pressures using designated ports.
How to cycle through measurement units like PSI, In-WG, mBar, and Pascals using the SCALE button.
Captures and displays minimum and maximum pressure values, resettable with MIN/MAX button.
Freezes the current reading on the display; press again to resume live measurement.
"OL" display signifies input exceeding meter range; disconnect immediately to prevent damage.
Crucial safety advice, including tubing checks, gas leak response, and professional operation guidelines.
Procedure to zero the meter before use in a non-pressurized area for accurate readings.
Connect tubes to measure positive, negative, or differential pressures using designated ports.
How to cycle through measurement units like PSI, In-WG, mBar, and Pascals using the SCALE button.
Captures and displays minimum and maximum pressure values, resettable with MIN/MAX button.
Freezes the current reading on the display; press again to resume live measurement.
"OL" display signifies input exceeding meter range; disconnect immediately to prevent damage.
General| Category | Measuring Instruments |
|---|---|
| Model | EM201B |
| Type | Clamp Meter |
| Display | LCD |
| Continuity | Yes |
| Audible Continuity | Yes |
| Battery Type | 2 x AAA |
| Safety Rating | CAT III 600V |
| Diode Test | Yes |
| AC Voltage Range | 0 to 600V |
| DC Voltage Range | 0 to 600V |
| Jaw Opening | 1.25 in (32mm) |
| Clamp Jaw Size | 1.25 in (32mm) |
To Next Page
