Need help?Do you have a question about the UEi HA1 and is the answer not in the manual?
Covers general safety advice, warnings, and cautions for instrument usage and physical hazards.
The combination 25A circuit breaker and POWER ON switch.
Switch for selecting one of three starting capacitor ranges.
Switches (REV/OFF/FWD, FAULT/CONT./START) for controlling compressor operation and test modes.
Buttons for ground, start, and run tests, plus indicator lights for line status.
Connectors for voltmeter/ohmmeter leads to compressor circuit.
Procedure for testing compressors using a 110 V AC power supply.
Step-by-step guide for standard 110 V AC testing procedures.
Guidance for testing when the 110 V AC receptacle is reverse wired.
Procedure for testing compressors using a 120 V AC power supply.
Instructions on connecting HA1 test cables to the compressor motor.
Steps for performing continuity and fault tests on motor windings.
Selecting the start capacitor and performing start/run tests.
Methods for attempting to free a locked rotor by 'bumping' the compressor.
Guidelines for calibration, keeping the meter dry, and avoiding dust.
Instructions for cleaning the meter case using a damp cloth.
Covers general safety advice, warnings, and cautions for instrument usage and physical hazards.
The combination 25A circuit breaker and POWER ON switch.
Switch for selecting one of three starting capacitor ranges.
Switches (REV/OFF/FWD, FAULT/CONT./START) for controlling compressor operation and test modes.
Buttons for ground, start, and run tests, plus indicator lights for line status.
Connectors for voltmeter/ohmmeter leads to compressor circuit.
Procedure for testing compressors using a 110 V AC power supply.
Step-by-step guide for standard 110 V AC testing procedures.
Guidance for testing when the 110 V AC receptacle is reverse wired.
Procedure for testing compressors using a 120 V AC power supply.
Instructions on connecting HA1 test cables to the compressor motor.
Steps for performing continuity and fault tests on motor windings.
Selecting the start capacitor and performing start/run tests.
Methods for attempting to free a locked rotor by 'bumping' the compressor.
Guidelines for calibration, keeping the meter dry, and avoiding dust.
Instructions for cleaning the meter case using a damp cloth.
General| Brand | UEi |
|---|---|
| Model | HA1 |
| Category | Measuring Instruments |
| Language | English |
To Next Page
