EasyManua.ls Logo

UKIAH TAILGATER - SETUP INSTRUCTIONS; Regulator and Tank Connection

Default Icon
24 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
14
[Figure 4] - Turn gas control to “OFF”.
[Figure 5] - Connect supplied regulator
and do not over-tighten.
[Figure 6] - Attach quick-connect end of
regulator to the unit.
REGULATOR CONNECTIONS:
Your Ukiah Co gas re pit is equipped with a specialized pressure
regulator, which is a device to control and maintain uniform gas
pressure as gas is released from the LP cylinder. This pressure
regulator is designed for vapor withdrawal.
WARNING: Use only the original specially designed regulator
supplied with your unit. Using another regulator may be dangerous.
WARNING: Use tanks that are marked “Propane Fuel” only.
WARNING: Read carefully all instructions contained on the
information plate attached to the re pit.
WARNING: Do not transport your re pit with LP Tank connected.
1. Place the re pit in the desired location. Make sure that it is placed
outdoors in a well-ventilated area away from any ammable structures,
awnings, vegetation, etc.
2. Place your 20lb LP tank in a location that is not in a walkway or
where it can be easily knocked over. Always use the provided tank
stand (see page 7 for details). Maintain 60 inches between the unit
and tank. For safest operation use a commonly-available LP tank
holder.
3. Make sure the unit gas control knob is turned to “OFF” by pushing
it in and turning it clockwise to the off position. [Figure 4]
4. Make sure the propane cylinder valve is turned off by turning valve
clockwise.
5. While holding carrying handle closest to propane cylinder, connect
regulator to propane cylinder and turn clockwise until snug (DO NOT
OVER-TIGHTEN). Use only supplied regulator included with your unit.
[Figure 5]
6. Attach quick-connect on opposite end of regulator hose to your
unit. [Figure 6]
WARNING: Do not over-tighten or use a wrench to tighten the
regulator connection. Over-tightening could damage the regulator
coupling and cause a leak.
LP TANK REMOVAL:
When the LP tank needs to be replaced, follow these instructions to
remove it.
1. Make sure gas control knob is turned “OFF” by pushing it in and
turning it clockwise to the off position.
2. While holding carrying handle closest to propane cylinder with one
hand, unscrew propane cylinder from regulator.
SETUP INSTRUCTIONS

Related product manuals