Ultimate Support JAMSTANDS JS-SRR100 User Manual

Setup Instructions - JS-SRR100
On stage, behind the board, or in the studio, sometimes you need your rack to roll with you. The Rolling Rack Stand easily accommo-
dates, boasting an 11U-over-8U rack on casters, two of which lock to keep your rack from rolling away. The top section is angle-
adjustable for convenience, and the frame is built from rugged steel for durability.
SETUP INSTRUCTIONS — JS-SRR100
5836 Wright Drive
•
Loveland, CO 80538
•
Phone. 1-800-525-5628
•
Fax. 970.776.1941
•
Web. www.ultimatesuppor t.com
R. 1, 08/31/10, JAM-HT_JS-SRR100
PARTS INCLUDED
:
A.
(
3
)
Cross bars
B.
(
2
)
Side angle bars with wheels
C.
(
1
)
Top rock
D.
(
1
)
Allen wrench (Tool)
E.
(
2
)
Tightening knobs
F.
(
6
)
Large screws
G.
(
6
)
Washers
H.
-
Bag of small screws & mounting clips
1. Using large screws, washers, and allen wrench
attach all three cross bars to one of the side
angle bars with wheels. Make sure mounting
holes are on the inside.
2. Line up all three cross bars with other side and
hand tighten large screws with washers. After
all three bars have been attached use an allen
wrench to finish tightening.
3. Attach top rack to assembled rack by lining up
rotating links over each other. Start with one
side and snap the other into place.
4. Screw in tightening knobs to both sides. These
are used to adjust top rack to desired angle.
5. Use a flat head screw driver too attach
mounting brackets. Use small screws to
attach equipment to mounting brackets.
STEP 3.
D.
E.
F.
G.
H.
A.
B.
C.
STEP 2.
STEP 4. STEP 5.
STEP 1.
Mounting holes
Rotating links

Ultimate Support JAMSTANDS JS-SRR100 Specifications

General

Brand	Ultimate Support
Model	JAMSTANDS JS-SRR100
Category	Racks & Stands
Language	English

Summary

Jamstands JS-SRR100 Setup Guide

Jamstands JS-SRR100 Parts List

Lists all components provided for the Jamstands JS-SRR100 rolling rack stand assembly.

Step 1: Attach Cross Bars to Side Angle Bar

Connects three cross bars to one side angle bar using large screws, washers, and an Allen wrench.

Step 2: Attach Remaining Side Angle Bar

Aligns cross bars with the second side angle bar and tightens screws using the provided Allen wrench.

Step 3: Mount Top Rack Section

Attaches the top rack section to the assembled frame by aligning and snapping rotating links into place.

Step 4: Adjust Top Rack Angle

Installs tightening knobs to adjust the angle of the top rack section for desired positioning.

Step 5: Attach Mounting Brackets

Secures mounting brackets using small screws and a flat head screwdriver for equipment attachment.