The UltraDial will call for an estimated time of 25-30 seconds (may differ for each network)
before moving onto the next number. Upon receiving the Call, you have the option to;
• Press # on the receiving telephone, which will disarm the alarm (and all other
Wireless accessories) and prevent it calling any of the other telephone numbers,
additional Sirens will also be silenced.
• Press * on the receiving telephone, which will prevent the alarm from calling any
other telephone number, but the Alarm will remain Armed, additional Sirens will also
be silenced.
Whilst using the Alarm with Battery, there is no option to Remotely Arm & Disarm the Alarm
(see further details about operation using a Transformer below).
Notes:
When 3 telephone numbers are entered, each number will receive 1 call & 1 SMS.
When 2 telephone numbers are entered, the first number will receive 2 calls and 1 SMS, the
second number will receive 1 call and 1 SMS.
When 1 telephone numbers are entered, it will receive 3 calls and 1 SMS.
Alarm Operation when using a optional DC Input:
Operating the Alarm whilst using a Plug in Transformer or USB Cable is identical to the
above instructions, however there are the following additions:
Remote Operation:
This allows the primary Key-holder to Remotely Arm & Disarm the Alarm by sending an SMS
to the SIM Card Number, the commands are:
D = Disarm.
A = Arm.
Power Failure:
In the event of a Mains Power Failure, the Alarm will contact the primary Key-holder by SMS
informing them in the event of a Power Cut and when the Power is reconnected (this
function will require the Alarm to also have batteries inserted.
Specification:
Wireless Frequency: 868 Mhz.
GSM Frequency:
Battery Life: Approximately 6 months (using Lithium Batteries).
Size: 163 x 82 x 40 mm.
Colour: Black.
IP Rating: IP66.
To Next Page
Loading...
Need help?
General