8
Installation Procedure
WARNING: The label on the alarm must not be removed as it shows important
information about the product.
2. Hold the baseplate against the ceiling at the desired installation position.
3. Mark the installation holes with a pencil.
5. Strike the two included plastic rawl plugs into the holes with a hammer.
7. Fit the batteries into the alarm.
8. Follow the instructions in the Radio-Interlink section.
10. After mounting, test the alarm as described in the Maintenance section.
1. Check the desired installation position for wires, pipes, or other obstructions
that would be dangerous to drill into.
6. Align the baseplate to the plastic rawl plugs and x in place using the
provided screws.
4. Drill the two installation holes as previously marked using a 5mm diameter
drill bit.
9. Line the alarm up to the baseplate and turn the alarm head clockwise, until
securely attached.
To Next Page
Loading...
