Ulvac GLD-040 - Page 4

(2/2)
2.2 How to Install Unplug-preventive Hardware
Install the unplug-preventive hardware in accordance with the procedure as follows:
(1) Let one end of the unplug-preventive hardware
catch the hole to the side of the inlet in the interior.
(2) While pushing the unplug-preventive hardware at
the other end, let it catch the hole to the side of the
inlet in the interior.
(3) Raise the unplug-preventive hardware.
(4) Insert the power cable firmly enough.
(5) Lower the unplug-preventive hardware and
secure the power cable.
Now, the unplug-preventive hardware is completely installed.
(1)
(2)
(3)
(4)
(5)