- 04 -
Do not use the pump in an explosive atmosphere. Failure to do so will result
in injury or fire.
When shipping from the factory, the motor is set for 100-120V class. Do not
operate with 200-240V power supply voltage. In order to operate with 200-240V
class, the changeover switch in the terminal box must be changed into 200-240V
class as shown in fig.3.4“Changing the voltage class.”
Never touch the rotating section of the motor, shaft or coupling while the
pump is in operation. Failure to do so will result in injury.
Never place combustible materials around the motor or pump. There is a risk
of fire.
Also, do not place objects which block ventilation around the motor. Abnormal
heat generation may result in burns or fire.
Do not touch the motor while the pump is in operation or when the pump is
still hot immediately after it stops. Touching it will result in burns.
Arrange wires correctly in accordance with the “Electrical Equipment
Technical Standard” and “Wiring Regulations.” Incorrect wiring may result
in fire.
Warning
Caution
Caution
Caution
Caution
Warning
To Next Page
Loading...
