SK00-4802-DI-002-04
No.16.10.20
xiii
0.6 Protective equipment
This machine comes equipped with a single-phase heater for 200 VAC or 220 VAC.
This heater has no protection equipment. Be sure to connect the heater to the power supply
through an overload protector. The electrical equipment technical standards (The government
ordinance No. 61, the Ministry of International Trade and Industry, 1965) mandate installation of an
overload protector.
For selection of an overload protector, see "3.6 Electrical connection."
It is recommended to install protectors other than the overload protector (such as a ground-fault
interrupter) together.
Be sure to attach overload protective equipment.
If you do not attach the overload protection equipment, then burned the
heater, power cable, it may result in a fire.
For the electric wiring and the overload protector, select, install, and
manage the wiring materials following the safety rules, laws and
regulations (such as fire laws and electric wiring rules) in the country
where you use the product.
CAUTION
To Next Page
Loading...
