the water. Humidity, dust and water could damage it and have an effect on its
functioning
ELECTRIC CABLE: Make sure that the cable and plug are in perfect
conditions. Electric cables must be away from hot surfaces
SCREWS AND CONNECTING CABLES: Supervise and tighten the
screws on a regular basis, because due to the vibration the screws and nuts
tend to loosen.
LUBRICATION: After running for a period of time, the treadmill must be
configured with special silicone oil for lubrication.
Do not lubricate more than what you need to. Remember: regular and reasonable
lubrication is to improve the lifespan of your treadmill.
Whether it is necessary to lubricate, make sure the
machine is switched off and unplug the electricity.
Lift the running belt, observe if there are any silicon
remaining on the running board which is under the
running belt. If it is dry, then you need to apply the lubricant.
a) The step to lubricate the running board is as follows: (see the above figure)
b) Stop the running belt and fold the treadmill.
c) Turn over the running belt at the back of the mainframe. Insert the lubricant
pot as deep as possible into the middle of the running belt. Apply the lubricant
onto the inner side of the running belt. Lubricate both sides of the running belt.
After the lubrication is completed, start the machine at 1km/h to let the running
belt bring silicon all over the board.
ALIGN AND TIGHTEN THE BELT OF THE TREADMILL
ALIGN THE BELT: Due to its use, the belt can
move off center. If the belt has moved to the left, start
treadmill and increase the speed to 3MPH .Use the
5mm
Wrench
to turn the fixed left bolt clockwise or turn the
To Next Page
Loading...