fixed right bolt counterclockwise. Don’t tighten the belt
too much in order to be able to walk. Repeat this
procedure until the belt is properly aligned.
TIGHTEN THE BELT: (if the belt slips on the
treadmill when walking). Start treadmill and increase the
speed to 3MPH.Using the
5mm Wrench
, turn both bolts
1/4 clockwise. If the belt is properly tight to walk, you
must be able to pull up each side of the belt 5 or 7 cm off
the platform. Be careful and maintain the belt aligned.
Repeat this procedure until the belt is properly
tightened.
TIGHTEN THE DRIVE BELT: if the drive belt
becomes loose after using for a period of time,you need to:
(1) Open the motor cover .
(2) Use the 5mm wrench to turn the adjusting
bolt clockwise.
Repeat this procedure until the drive belt is not
slippery anymore.
如果跑带左偏,则顺时针调节左
边螺丝或逆时针调节右边螺丝
如果跑带右偏,则顺时针调节右
边螺丝或逆时针调节左边螺丝
If deviate to the right, then
adjust the screw on the right side
clockwise or the screw on the left
side anticlockwise.
If deviate to the left, then
adjust the screw on the left side
clockwise or the screw on the
right side anticlockwise.
if the running belt slips,use 6mm wrench,turn
both sides bolts 1/4 clockwise.Repeat this
procedure until the belt is properly tightened.
To Next Page
Loading...