UNI-T UPO3000E Series - Page 10

UNI-T
UPO 3000E&UPO2000E Series Oscilloscope Programming Manual
:SYSTem:CYMOmeter
 Command format：
:SYSTem:CYMOmeter {1 | ON} | {0 | OFF}
:SYSTem:CYMOmeter?
 Functional description：
The switch of frequency meter.
 Return format：
Query return frequency meter status，1 presents on, 0 presents off.
 For example：
:SYSTem:CYMOmeter ON turn on frequency meter
:SYSTem:CYMOmeter? query return1
:SYSTem:SQUare:SELect
 Command format：
:SYSTem:SQUare:SELect { 10Hz | 100Hz | 1KHz | 10KHz }
:SYSTem:SQUare:SELect?
 Functional description：
Select square wave output.
 Return format：
Query return{ 10Hz | 100Hz | 1KHz | 10KHz }.
 For example：
:SYSTem:SQUare:SELect 10Hz select 10Hz square wave output
:SYSTem:SQUare:SELect? query return 10Hz
:SYSTem:OUTPut:SELect
 Command format：
:SYSTem:OUTPut:SELect { TRIGger | PASS_FAIL }
:SYSTem:OUTPut:SELect?
 Functional description：
Set output selection, TRIGger, PASS_FAIL（pass &fail）.
 Return format：
Query return{ TRIGger | PASS_FAIL }.
 For example：
:SYSTem:OUTPut:SELect TRIG select TRIG
:SYSTem:OUTPut:SELect? query return TRIG