Need help?Do you have a question about the UNI-T UT181A and is the answer not in the manual?
General| Brand | UNI-T |
|---|---|
| Model | UT181A |
| Category | Measuring Instruments |
| Language | English |
Outlines the product's warranty terms and liability limitations.
Lists the general specifications and performance parameters of the UT181A meter.
Details the accuracy and range specifications for AC voltage measurements.
Details the accuracy and range specifications for DC voltage measurements.
Details specifications for AC+DC voltage measurements.
Details accuracy and range specifications for AC current measurements.
Details accuracy and range specifications for DC current measurements.
Details specifications for AC+DC current measurements.
Details accuracy and range specifications for resistance measurements.
Details accuracy and range specifications for conductance measurements.
Details accuracy and range specifications for capacitance measurements.
Details accuracy and range specifications for temperature measurements.
Details specifications for frequency, duty cycle, and pulse width measurements.
Details specifications for continuity testing, including buzzer behavior.
Details specifications for diode testing, including forward voltage drop.
Covers how to turn the meter on/off, battery indicators, and backlight control.
Details how to configure meter settings like keypad tone, alarms, date/time, and power save.
Explains access to help language, memory format, reset, and product information.
Provides step-by-step instructions for measuring AC voltage with the meter.
Provides step-by-step instructions for measuring DC voltage with the meter.
Details how to measure AC and DC current using the meter.
Explains how to measure resistance, including attention points.
Details the procedure for measuring conductance.
Explains how to measure capacitance, including precautions.
Describes how to perform a continuity test and interpret results.
Explains the procedure for testing diodes and interpreting forward voltage drop.
Covers measuring frequency, duty cycle, and pulse width.
Provides instructions for measuring temperature using probes.
Explains how to use the Low Pass Filter (LPF) for AC measurements.
Details how to perform dBV (decibel-volt) measurements.
Explains how to perform dBm (decibel-milliwatt) measurements.
Describes how to activate and use the MAX/MIN value recording features.
Explains how to use the relative value (REL) measurement mode.
Details how to activate and use the peak detection function.
Explains how to set up and use the compare mode for measurements.
Covers modes for single, continuous recording, and data management.
Explains how to view recorded measurement events and their details.
Describes the process to delete all saved recording events.
Covers routine cleaning and general care for the meter.
Details how to test fuses for continuity and proper function.
Provides steps for safely replacing fuses in the meter.
Explains how to charge the meter's internal battery.
To Next Page
