UT3200 Series User Manual
14
Data acquisition module in the first row on the right, from left to right, correspond to
CH25 CH26 CH27...CH32 channel
Other model data acquisition module of other Instrument are also sorted in the
same way.
Figure 3-4-1 UT3232
3.4 USB
Instrument is equipped with an 8G USB, USB recording function only use Test,
Histogram figure, Curve figure page. Before starting data collection, insert the USB into
Instrument interface.
About USB recording function, you can refer to the contents of section 6.1.4-6.1.6
It is recommended to use brand USB to avoid the problem of incompatible
identification. The format and capacity of the USB can be referred to FAT, FAT32 and
EXFAT, with the maximum capacity of 128G.
3.5 Operation guide
▪ Connect power correctly
▪ Turn on Instrument switch, the screen will light up. Check the contact lines of each
temperature are connected well. Start to collect data, if the connection is wrong,
there is no temperature display on this connection line; if the connection is normal,
temperature will display.
▪ Inter USB into Instrument interface
▪ Select the test part to fix the temperature connection line layout with glue. The layout
must be attached to the test surface to avoid the value precision. You can use the
channel identification sticker to distinguish different test lines
To Next Page
Loading...
