EasyManuals Logo

UNI-T UT39A User Manual

UNI-T UT39A
28 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #4 background image
Safety Information
This Meter complies with the standards IEC61010: in
pollution degree 2, overvoltage category (CAT. I 1000V,
CAT. II 600V) and double insulation.
CAT. I: Signal level, special equipment or parts of
equipment, telecommunication, electronic, etc., with
smaller transient overvoltages than overvoltages CAT. II.
CAT. II: Local level, appliance, PORTABLE EQUIPMENT
etc., with smaller transient voltage overvoltages than
CAT. III
Use the Meter only as specified in this operating manual,
otherwise the protection provided by the Meter may be
impaired.
In this manual, a Warning identifies conditions and
actions that pose hazards to the user, or may damage
the Meter or the equipment under test.
A Note identifies the information that user should pay
attention on.
International electrical symbols used on the Meter and
in this Operating Manual are explained on page 7.
4
Model UT39A/B/C: OPERATING MANUAL

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the UNI-T UT39A and is the answer not in the manual?

UNI-T UT39A Specifications

General IconGeneral
Diode testYes
Product typeDigital multimeter
AC current range0.0002 - 10 A
AC voltage range2 - 750 V
DC current range0.00002 - 10 A
DC voltage range0.2 - 1000 V
Capacitance range2000 nF
Basic accuracy (DC current)±(0.8%+1)
Basic accuracy (DC voltage)±(0.5%+1)
Dimensions (WxDxH)83 x 38 x 172 mm
Battery voltage9 V
Weight and Dimensions IconWeight and Dimensions
Weight310 g

Related product manuals