Need help?Do you have a question about the UNI-T UTL8200 Series and is the answer not in the manual?
General| Brand | UNI-T |
|---|---|
| Model | UTL8200 Series |
| Category | Test Equipment |
| Language | English |
Introduces the manual and outlines copyright details.
Explains the terms and conditions of the product warranty and its limitations.
Provides critical safety warnings and guidelines to prevent injury and damage.
States important disclaimers and precautions for instrument usage.
Introduces the UTL8200 series, its models, and key operational features.
Details the electrical and performance specifications for UTL8211 and UTL8212 models.
Identifies and describes the function of each element on the front panel of the UTL8212 model.
Explains the function of buttons and available shortcut key combinations for efficient operation.
Lists package contents and specifies required voltage, frequency, and power for operation.
Outlines environmental conditions for use and provides instructions for safe cleaning procedures.
Guides users through the correct power-on sequence and initial self-check process.
Explains screen display areas, status information, and running indicators for measurements.
Covers configuration of CC, CV, CR, CP, Dynamic, List, and Battery test modes.
Details the steps to perform a short circuit test in various operating modes.
Explains methods for inputting parameters and controlling the load's operational status.
Lists and explains potential alarms, protections, and error conditions encountered during operation.
Describes how to switch between and use local manual control and remote PC control.
Covers settings for language, knob behavior, sounds, initial mode, and factory reset.
Details the setting ranges for operating parameters and protection settings like limits and times.
Explains how to recall and delete list test files stored in the instrument's internal flash.
Shows how to access basic information such as model, version, and serial number.
Describes the RS232 interface, its pinout, and connection requirements for remote control.
Guides on setting address and baud rate to match the upper computer for successful communication.
To Next Page
