Need help?Do you have a question about the UNI-T UT527 and is the answer not in the manual?
General| Data Hold | Yes |
|---|---|
| LCD Backlight | Yes |
| Alarm Light Display | Yes |
| Over Range Indication | Yes |
| Auto Power Off | Yes |
| Low Battery Indication | Yes |
| Type | Insulation Resistance Tester |
| Display | LCD |
Instructions for opening the case and checking the PAT tester and its accessories.
Highlights important safety precautions and warnings to be aware of before and during use.
Details the function of each button for powering on/off and selecting specific test modes.
Explains the procedure for zeroing the earth bond test lead to ensure accurate readings.
Details the Earth / Protective conductor test procedure and pass/fail criteria for Class 1 appliances.
Describes the insulation resistance test for Class 1 appliances and how to proceed if connections are not detected.
Indicates the overall pass or fail status after completing the tests for an appliance.
Explains the pre-check for Class 2 appliances and what happens if an earth connection is detected.
Details the insulation resistance test for Class 2 appliances, including handling electronic switches.
Indicates the overall pass or fail status after completing the tests for a Class 2 appliance.
Details the Earth Bond Test procedure for cord sets, including the pass mark.
Describes the Insulation Test for cord sets, noting potential failures with surge-protected leads.
Explains the Polarity Test to check for correct wiring, open circuits, or line/neutral reversal.
Indicates the final compliance of the tested cord with 'PASS' or 'FAIL' criteria.
Step-by-step guide for replacing the batteries in the UT527 unit when the low battery indicator appears.
To Next Page
