Need help?Do you have a question about the UNI-T UTD3025C and is the answer not in the manual?
General| Bandwidth | 25 MHz |
|---|---|
| Channels | 2 |
| Input Voltage Range | 400V (DC+AC Peak) |
| Type | Digital Oscilloscope |
| Display | 5.7-inch TFT LCD |
| Display Type | Color |
| Trigger Modes | Edge, Pulse, Video |
| Interface | USB |
Overview of safety precautions for operating the instrument correctly and avoiding hazards.
Guide to basic operations and front panel functions of the oscillograph.
Detailed setup procedures for various instrument systems and functions.
Initial checks and inspection of the instrument upon receiving it.
Procedure for adjusting probe compensation for accurate measurements.
Configuration options for the vertical channels, including coupling and bandwidth.
Adjusting horizontal time base, position, and view window extension.
Setting up trigger modes, sources, coupling, and pulse width.
Using cursors for precise voltage and time measurements on waveforms.
Measuring signal frequency and peak value of a simple unknown signal.
Capturing single aperiodic signals like pulses and burrs using trigger settings.
Analyzing phase location difference between signals using X-Y display mode.
Configuring and performing pass/fail tests based on signal tolerance scopes.
To Next Page