Unic Stella di Caffe Quick Start Guide

Tools required:
- Flat screwdriver
- Philips screwdriver, P1
- Switch the machine off and unplug.
- Loosen the two screws (A) under the side grilles of the cup warmer by approximately 7 turns and
release the front panel from the hooks by pushing the screws downward.
- Tilt the front panel forward to gain access to the wiring connections.
- Disconnect both wiring connections from BTA and the following connections from each BGX: CN1,
CN4, CN5, CN6.
A
- Place the front panel flat on a protected surface to avoid scratching it and to have access to the
screws on the back.
 BGX/BST control box replacement:

Unic Stella di Caffe Specifications

General

Brand	Unic
Model	Stella di Caffe
Category	Coffee Maker
Language	English