Unic Stella di Caffe Quick Start Guide

- Loosen the screws holding the top of the panel (B) to remove it.
- Remove the light diffuser strip.
- Disconnect all wiring harnesses from the control box to be changed and remove its four screws
- Also loosen the screws holding the adjacent BGX control boxes to leave enough clearance to be
able to remove the control box being changed. DO NOT REMOVE/LOOSEN BTA SCREWS!
- Position the new control box and reassemble.
B
 Assignment of one or more BGX/BST control boxes
Reconnect machine to power and turn on: IMMEDIATELY proceed to BGX assignment.
Following BGX replacement, assignment must be complete (confirmed) within 30sec after
powering machine on.
The replaced BGX control box[es] flash green while awaiting the assignment of their positions
1°: G1 flashes: press upper
left key to change
assignment
2°: When appropriate position
is selected - press upper right
key to confirm assignment
3°: Assigned position stops
flashing when confirmed -
machine will start normally
after software booting

Unic Stella di Caffe Specifications

General

Brand	Unic
Model	Stella di Caffe
Category	Coffee Maker
Language	English