Unic Tango Ace - Cleaning Cycles Procedures

32
Tango 0060 11-2019
Reinstall Turntable drive-
shaft
Rotate Turntable to align
shafts before sliding coupler
up
Install locking collar
Don’t over tighten, nal ten-
sion adjustments are made
after machine is ON
Check tension of Turntable
Re-adjust if needed
Can not move by hand,
takes some eort to turn
with wrench
Check tension
of Turntable
Re-adjust 22mm nut
until tension is very rm
Note: If the Initial tension setting is too
tight or loose, nal adjustment
will not be possible.
The metal tab will not stop inside the
sensor when switched ON.
Fault Code 4 will display.
Re-adjust tension as above if this occurs.
Tango Turntable Service
Bearing Tension Initial Adjustment
D
EC
B
A
F